![]() Serial.println(F("What would you like to do?")) Adafruit_Soundboard sfx = Adafruit_Soundboard(&ss, NULL, SFX_RST) Īdafruit_Soundboard sfx = Adafruit_Soundboard(&Serial1, NULL, SFX_RST) ![]() argument is the debug port (not used really) and the third ![]() pass the software serial to Adafruit_soundboard, the second SoftwareSerial ss = SoftwareSerial(SFX_TX, SFX_RX) You can also monitor the ACT pin for when audio is playing! Connect to the RST pin on the Sound Board Choose any two pins that can be used with SoftwareSerial to RX & TX Pause, unpause, quit playing (when playing audio)Ĭurrent play time, and bytes remaining & total bytes (when playing audio)Ĭonnect UG to ground to have the sound board boot into UART mode Vol + and - (only when not playing audio) Hard reset and List files (when not playing audio) Menu driven control of a sound board over UART.Ĭommands for playing by # or by name (full 11-char name) I am using an LDO 5V to provide power to the Sound board. I am attaching pictures of my configuration *************** I appreciate any help you guys can give. I have searched forums, across the internet and did everything that people suggest but no luck. I have tried to set the TX/RX pins all around the arduino board tried it with different pins but to no success.Ĭan I have you guys test it out for me. Also I verified that the board entered into UART mode by trying to use the GPIO which doesn't work. I have verified that reset pin does reset the board by pulling it LOW and it does reset the board you can tell because the speakers do a little pop sound. The GPIO mode works but when I ground UG It stops working. I have checked that the pin are doing what they should. I am using an Arduino Mega 2560 to control the board serially. I checked the connections and they are solid. Adafruit Audio FX Sound Board + 2x2W Amp - WAV/OGG Trigger -16MB PID: 2217īoard is not working.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |